Step 1:

Ensure the skin is clean and dry before application. Find the exact position that you are happy with on the skin.

Step 2:

Apply a thin layer of adhesive to BOTH the skin and the back of the prosthetic and let them both go dry/clear/tacky. This is a contact glue so when each layer touches its binds to itself.

Step 3:

When you are happy with the position, gently apply the piece to the correct position focusing on the middle section out and smooth outwards to the edges. It can help to do this with a sponge.

Step 4:

Using a brush or cotton bud dipped in acetone, gently soak around the edge of the flashing (silicone border around the prosthetic). Gently blend the edge of the thin plastic and dissolve the edge against the skin and make it disappear!

Step 5:

If you are struggling to hide an edge, we advise adding a stippled layer of prosaide around the edge and let it dry. You can then dust this with some powder to seal it before painting.

Step 6:

Once the edges are dissolved and blended onto the skin, add another layer of loose powder to get rid of any tacky adhesive. Now you are ready to paint your prosthetic! You can use alcohol activated paints, water based paints, grease/oil based paints or even regular make up. Once you have finished painting you use a setting spray to seal the application.